Your shopping cart is empty!


Uninterruptible power supply unit ABP5-33-AO

Парус электро


Industrial uninterruptible power supply unit ABP5-33-AO is a three-phase guaranteed power supply system for industrial equipment with a capacity of up to 100 kVA. Industrial UPS ensures uninterrupted operation of CNC machines, technological equipment, oil pumping stations and other production facilities.

UPS cabinet in dimensions of a standard 19" allows you conveniently place it together with other equipment. Modular design of power section increases fault tolerance of the system and greatly simplifies it scaling and repair.

An additional galvanic isolation transformer increases the level of safety during operation and by advanced monitoring system with metrological accuracy provides reliable control of the power status in real time.


  • With an output power factor of 1.0 active power is up to 100 kW
  • Three-phase modular system with double conversion and zero switchover time to batteries
  • Flexible power module redundancy system
  • Minimal load on the mains or generator due to the low input harmonic distortion coefficient
  • Optional transformer for galvanic isolation of input and output
  • Separate bypass input


  • RS-485 control interface with ModBus protocol and optional SNMP adapter
  • Remote Emergency Power Off (REPO)
  • General 7" touchscreen LCD display
  • Digital LCD display on each power module

Installation and operation

  • Cabinet UPS in dimensions 19" telecommunication rack with built-in batteries for compact placement
  • Version with degree of protection up to IP41 (optional)
  • Wide input voltage and frequency range with customizability
  • High conversion efficiency up to 95.5%
  • Easy modules replacement
  • MTBF of up to 250 000 hours
  • High efficiency mode for energy saving (ECO mode)
  • Intelligent battery charging to extend battery life
  • Automatic self-test to increase system reliability
Product Code: 1299-28
UPS model ABP5-33-AO
Apparent Power, kVA 100
Active power, kW 100
Input phases 3 phases
Output phases 3 phases
Form factor Modular
Warranty 24 months
Rated input voltage 380, 400, 415 V
Rated voltage range 208 ~ 478 V (with the ability to configure a wide range)
Input frequency range 40 ~ 70 Hz
Rated input current 100 ampere
Input power factor ≥ 0,99
Total harmonic distortion at the input Less than 3% at full non-linear load
Voltage range in ECO mode ± 10%
Input connection type Connection terminal: three phases, neutral and ground
Rated output voltage 380, 400, 415 V
Output voltage accuracy ± 1 %
Topology and form of the output voltage Online UPS with pure sine wave output
Distortion of the output voltage ≤2% on linear load
Output frequency (battery mode) 50, 60 Hz ±0.2%
Output power factor 1.0
Peak load ratio 3:1
Overload capacity When working from the mains: up to 110% - 60 minutes, up to 125% - 10 minutes, up to 150% - 1 minute
Efficiency in online mode ≥ 95%
Efficiency in ECO mode ≥ 98%
Surge Protection 4*600 J
Filtering Integrated filter
Type of output connection Connection terminal: three phases, neutral and ground
Bypass circuit (bypass)
Bypass type Electronic and manual service bypass
Bypass voltage range From +15% up to -45% (customizable max +5%, +10%, +25% and min -20%, -30%)
Bypass frequency range ±10%
Built-in battery Yes
Battery Type Leak-acid sealed with leakage protection
Quantity of internal batteries Battery module
DC bus voltage ± 192 V (settable ±204, 216, 228, 240 V) direct current (DC)
Battery life (50% and 100% load) Depending on the capacity of the connected battery cabinet
Recharge time Depending on the capacity of the connected battery cabinet
Charge mode Intelligent charge with temperature compensation voltage
Charge current Up to 30 ampere
Transfer time to batteries 0 ms - from mains to battery, 0 ms - from mains to bypass
Battery Protection Over discharge, overvoltage and short circuit protection
Communications and Interfaces
Interface ports RS485
Internal slot for control card Optional SNMP module
Emergency power off (EPO) Do have
LCD display and indication Touch 7'' LCD and digital display on each power module
Sound alarm Mains failure, low battery, overload, UPS error
Working Conditions
Operating temperature 0°C ~ 40°C
Operating relative humidity 0 ~ 95 %
Operating height above sea level 0 ~ 3000 meters - up to 85% load, 0 ~ 1500 meters - 100% load
Storage temperature -25°C ~ +55°C
Storage height above sea level 0 ~ 10000 meters (recommended)
Protection class IP20, optional other degrees of protection available
Heat dissipation in online mode Up to 18430 BTU/hour
Noise level Less than 70 dB
Physical Characteristics
Unit size (W х D х H), mm 600x850x2100
Shipping Unit size (W х D х H), mm 800x1200x2300
Net weight, kg 350 (without power modules and battery)
Shipping weight, kg 400 (without power modules and battery)
Compliance with standards
Safety TR TS 004/2011, IEC 62040-1, IEC 60950-1
ЕМС TR TS 020/2011, IEC 62040-2, IEC 61000-4

Official website of the company: © Parus Electro, 2011-2020

All information published on the website is for guidance only and under no circumstances is a public offer determined by the provisions of Article 437.

Uninterruptible power supply equipment: UPS (Uninterruptible Power Supply), Rechargeable batteries.